Deleting Data In Memory; Keeping Data In Memory; Service And Repair; Service And Repair Contact - Hürner WeldControl 160-R Bedienungsanleitung

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
When data transfer is completed, an "OK" button appears on the PC
screen, and the welding machine displays a "Printing finished" mes-
sage.
5.5

Deleting Data in Memory

The report data in memory can be deleted only if all welding reports
were already printed. When printing is finished, a "Printing finished"
message indicates this. When the printer cable is unplugged, a "Delete
Memory" message is displayed. When the START/SET key is pressed
here, a further confirmation message "Delete Memory, sure?" is shown,
which has to be confirmed by pressing the START/SET key once again.
Then, the report data in memory is deleted.
For every data printing or transfer, always be sure to wait
until the display shows the "Printing finished" message
before you disconnect the printer, PC, or USB stick from the
Important
welding system. If you disconnect it too early, the welding
system may ask you whether you want to delete the data in
memory, although the reports were not properly transferred
or printed. In this case, if you delete the contents of the data
logging memory, the welding reports would be irrevocably
lost and would not have been saved elsewhere.
5.6

Keeping Data in Memory

When the printer cable is unplugged, a "Delete Memory" message is
displayed. Press the STOP/RESET key to keep the current report data
in memory. They can then be printed off once again.
6

Service and Repair

As the product is used in applications sensitive to safety considerations,
it may be serviced and repaired only on our premises or by partners
who were specifically trained and authorized by us. Thus, constantly
high standards of operation quality and safety are maintained.
Non-compliance with this provision will dispense the manu-
facturer from any warranty and liability claims for the ma-
chine and any consequential damage.
Important
7

Service and Repair Contact

Hürner Schweisstechnik
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Web: www.huerner.de
We reserve the right to change technical specifications of
the product without prior notice.
Info
Version April 2011
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HÜRNER WeldControl 160-R User's Manual
23
EN