Operating Elements And Connections; Safety Notes - Monacor Security TVCCD-480COL Bedienungsanleitung

Please unfold page 3. Then you can always see the
GB
operating elements and connections described.

1 Operating Elements and Connections

(figs. 1 et 2)
1 Protection cover
2 C mount adapter ring for screwing a lens with C
mount thread
3 Thread ring for screwing a lens with CS mount thread
4 Hexagon head screws for adjusting the mechanical
focus setting for the lens
5 Adapter with thread jack [thread 6.3 mm (
mounting the camera; it can be screwed to the top
side or bottom side of the camera
6 Level control for the video signal for compensating
cable loss if a long camera cable is used (cable
length > 100 m)
7 Selector for adjusting the camera to the AI lens type
used [AI = "auto iris" (automatically controlled iris)]
"VIDEO": when using a video signal controlled lens
("video iris" lens)
"DC": when using a DC voltage controlled lens
("DC iris" lens)
8 On/off switch for the automatic electronic shutter
9 Low voltage jack (drill hole Ø 5.5 mm, centre contact
Ø 2.1 mm; centre contact = positive pole) for the
connection to the power supply (12 V )
10 Control for adjusting the video signal level when
8
using a DC voltage controlled lens
11 Jack for connecting a lens with automatic iris control
[AI ("auto iris") lens]; see fig. 3
in case of a video signal controlled lens
("video iris" lens)
pin 1: video signal
pin 3: not connected
in case of a DC voltage controlled lens
("DC iris" lens)
pin 1: control –
pin 3: drive +
12 BNC jack for the video output
1
/ ")] for
4

2 Safety Notes

The camera corresponds to the directive 89/336/EEC
for electromagnetic compatibility.
The camera is only suitable for indoor use. For out-
side mounting it must be placed into a weatherproof
housing.
Protect the camera against dust, humidity, and heat
(admissible ambient temperature range 0 – 40 °C).
Align the camera so that the lenses of the lens
assembly are not exposed to direct sunlight. This
might damage the CCD image sensor chip.
If the camera is used for purposes other than orig-
inally intended, if it is not connected or operated cor-
rectly or not repaired in an expert way, there is no lia-
bility for possible damage.
pin 2: output 9 V
pin 4: ground
pin 2: control +
pin 4: drive –