Herunterladen Inhalt Inhalt Diese Seite drucken

Selecting The Gear; Working Led; Adjusting The Torque - Westfalia 84 94 37 Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operation

Selecting the Gear

This impact screwdriver is equipped with a two
gear transmission. With the speed selector (1)
on top of the impact screwdriver you can
change the gears.
Use the setting 2 for high speed for drilling and
hammer drilling, and the lower setting 1 for
driving in screws.

Working LED

When pressing the ON/OFF trigger the work LED
turns on automatically in order to light up the
working area.

Adjusting the Torque

You can control the maximum torque applied to the drill bit with the
torque setting ring (2). Attention! The torque setting ring should only be
operated when the impact screwdriver is not running; otherwise the
impact screwdriver may be damaged.
To set the drill to the lowest available torque setting, twist the torque
control ring until the small arrow marking on the drill-housing points to
the "1" printed on the torque control ring. In this position the torque
clutch will slip with light drilling resistance.
The higher the number the arrow points to on the torque control ring,
the larger the maximum torque that can be applied before the torque
clutch will slip.
To set the impact screwdriver to maximum available torque twist the
torque control ring until the arrow points to the drill symbol. In this
position there is no slip in the torque clutch.
For hammer-drilling adjust the machine to the hammer symbol.
Select a lower torque for inserting or removing of screws to avoid
damage the work-piece. For drilling select a higher torque setting. First
do a test on an item which is not your final work-piece and adjust the
desired torque accordingly before you start the actual work.
13

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis