Front Support Wheel; Filling With Fuel; Filling With Motor Oil; Operation - CMi C-B-BH-87/55 Originalbetriebsanleitung

Motorhacke_401140.book Seite 23 Freitag, 18. Oktober 2013 8:30 08
– Retighten the safety lever (25).
Coupling handle
► P. 3, item 1
When the coupling handle is released, the
cable pull must be completely relaxed; When
the coupling handle is pulled, the cable pull
must be tensioned in such a way that the
spring on the coupling handle starts to
extend.
– Coupling handle pulled (position [ ]) =
Chopping tool turns;
– Coupling handle released (position [
= Unit is running in idle.
Chopping spur
► P. 4, item 4
The forwards movement of the unit is braked
by the chopping spur. The required chopping
depth is achieved by digging the spur into
the ground at different depths.
(► Mounting the chopping spur – p. 22)

Front support wheel

► P. 5, item 6
The front support wheel makes it easier to
push the unit. When chopping, it must be
folded upwards.
– Pull the front support wheel from the
fixed position.
– Fold the front support wheel upwards
and click into place.

Filling with fuel

► P. 3, item 2
DANGER!
Risk of injury!
Petrol is extremely flammable!
– Switch off the motor and allow to
cool down before refilling.
– Observe all of the safety notes for
handling fuels.
NOTICE!
Risk of damage to the device!
The unit is delivered without motor
oil.
Motor oil must be filled before start-
ing the machine.
Note:
Only use suitable fuels (► Fuel and
lubricants to be used – p. 28).
– Unscrew the tank lid (7) and remove.
– Carefully pour fuel into the tank (max.
1600 ml). Do not spill!
– Check the seal in the tank lid for dam-
ages, and clean if necessary. Immedi-
ately replace damaged seals!
– Tighten the tank lid (7) by hand.
])
STOP

Filling with motor oil

► P. 3, item 2
– Unscrew the motor oil filling screw (12)
and remove.
– Fill with motor oil carefully. Do not spill!
– Tighten the motor oil filling screw (12) up
again by hand.

Operation

Check before starting the device!

NOTICE!
Risk of damage to the device!
The unit is delivered without motor
oil.
Motor oil must be filled before start-
ing the machine.
Operating the motor with insufficient
oil will damage the motor.
Direct oil and oil designed for two-
stroke motors will shorten the lifetime
of the motor.
Use the prescribed motor oil (► Fuel
and lubricants to be used – p. 28).
DANGER!
Risk of injury!
The device may only be put into
operation if there are no defects. If a
part is defective, it must be replaced
before the device is used again.
Check to make sure the device is in safe
operating condition:
– Check that no leaks have developed.
GB
23