Cleaning And Maintenance - Lux Tools 468273 Gebrauchsanweisung

468273_Trimmer_Elektrisch.book Seite 37 Mittwoch, 11. November 2015 11:39 11
Extending the cord
If the device no longer cuts cleanly, the cords have
become too short.
The best cutting results are achieved if you extend
the cords such that they are cut by the knife to the
right length.
Extending the cords during cutting operation
– Briefly tap on the floor with the underside of the
cord spool while the device is running.
– Tap once again if the cords have not been exten-
ded far enough.
The cords are automatically cut to the right length by
the cutting knife.
Extending the cords by hand
WARNING! Risk of injury! Always pull
out the mains plug (disconnect the pro-
duct from its power supply) before com-
mencing work on the product.
If the cords have already become too short they will
not extend by tapping. You must pull them out of the
cord spool by hand.
– Place the product on the ground.
– Press your hand on the underside of the cord
spool and pull the two cords out until they are
slightly longer than the edge of the protective
shield.
The cords are cut to the right length by the cutting
knife when used again.

Cleaning and maintenance

DANGER! Danger of death! Always pull
out the mains plug (disconnect the pro-
duct from its power supply) before com-
mencing work on the product.
Cleaning and maintenance at a glance
Before each use
What?
Check the power cable
and plug for damage.
Check device for
damage.
How?
Visual inspection, if
necessary, have any
damaged parts replaced
by an electrician.
Visual inspection.
As required
What? How?
Clean the device. Wipe the device with a
slightly damp cloth.
Replace the cord if it is Changing the cord.
too short.
Cleaning the product
DANGER! Danger of electric shock!
Never spray the product with water or
expose it to water. Never use detergents
or solvents for cleaning. This can cause
irreparable damage to the product. The
plastic parts can be eaten away by chemi-
cals.
Careful handling and regular cleaning ensure that the
product remains functional and efficient for a long
time.
• Remove any dirt using a brush.
• Wipe down the product with a slightly damp
cloth.
• Keep ventilation slots clean and free of dust.
Changing the cord
DANGER! Danger of death! Always pull
out the mains plug (disconnect the pro-
duct from its power supply) before com-
mencing work on the product.
WARNING! Risk of injury! After switching
the product off, the cords continue to
rotate for a few seconds.Do not touch
rotating cords.
WARNING! Risk of injury! On the under-
side of the protective hood there is a
sharp cutting knife for cutting off the cord.
Everytime wear protective gloves when
working with cutting knife.
It is possible to replace the entire cord spool or just
the cord.
Remove cord spool and replace cords
Figure 7 – Page 5
– Loosen fastening screw (15) on the cord
head (16) and remove cord spool (17).
– Fully remove cord residues.
– Hook two cords in the openings (18) of the
spool.
Figure 8 – Page 5
– Tightly turn cords to the spool.
GB
37