Removing The Blender Attachment; Cleaning The Hand Blender - Zwilling 36470-000 Bedienungsanleitung

Operating the hand blender
1
2
Fig. 7: Removing the blender
attachment
Fig. 8: Caution: Blades and
moisture

4.3 Removing the blender attachment

CAUTION!
Risk of injury and property damage due to rotat-
ing blade! The appliance continues to run briefly
after it has been switched off.
Do not remove the blender attachment from
ƒ
the working container until the appliance has
come to a standstill.
1. Unplug the power plug from the socket.
2. Twist the blender attachment off of the drive
unit (Fig. 7).

4.4 Cleaning the hand blender

WARNING!
Risk of injury and property damage due to incor-
rect cleaning:
Switch off the appliance and unplug the
ƒ
power plug from the socket before you re-
move the blender attachment and clean the
appliance.
Never immerse the drive unit in water or oth-
ƒ
er liquids. Do not clean the drive unit under
running water.
Only clean the drive unit and power cable
ƒ
with a soft, slightly moistened cloth.
Never completely immerse the blender at-
ƒ
tachment in water or other liquids. This is to
prevent water from penetrating the upper part
(Fig. 8).
In the event that water has penetrated the
ƒ
blender attachment, let the attachment dry
thoroughly and only use it again if it is com-
pletely dry.
Do not use any hard cleaning utensils, such as
ƒ
steel wool, or any sharp or corrosive cleaning
agents to clean the appliance.
Do not touch the blades (Fig. 8).
ƒ
EN
31