Use; Using The Product Without A Power Connection; Corded Use Of The Product; Fixing The Product - LIVARNOLUX HG01386A Bedienungsanleitung

Note: The product is fitted with an overcharge protection circuit. Despite this, you should disconnect
the LED inspection lamp from the power supply after the charging process is complete.
Note: During charging, the charging indicator (LED work light)
complete, the charging indicator (LED work light)
(LED work light)
3
adaptor from the product to prevent the rechargeable battery from discharging.
10

Use

Q
CAUTION – RISK OF ACCIDENT! Always store and secure the product in such a way that
there is no risk of injury from or damage to the product, even during full braking.
Note: The product features magnets
isable to carry the weight of the product, before you use the magnets
U sing the product without a power connection
F ully charge the product as described in the section "Charging the product".
Press the ON / OFF switch
P ress the ON / OFF switch
at the same time.
Press the ON / OFF switch

Corded use of the product

U se the included mains adaptor
the product to a suitable power supply.
T hen proceed as described under „Using the product without a power connection" (starting with step 2).
NOTE: The product can only be charged whilst off!

Fixing the product

Q
The product can be used in 2 ways without having to hold it in your hand:
H old the magnets
F old out the hook
turned through 360 degree.
M ounting the charging station (see Fig. C)
Note: You will need an electric drill.
CAUTION! RISK OF INJURY! Please read the operating instructions for your drill.
CAUTION! Ensure that you do not damage any electricity cables in the wall or ceiling.
10 GB
is green, pull the mains adaptor
on the back. Ensure the metallic surface is sufficiently magnet-
6
to turn the inspection light
4
again to turn the torch
4
the third time, the entire product will be switched off.
4
for this purpose. Using the respective mains adaptor
10
against a metallic magnetic surface. The product remains in this position.
6
to suspend the product from a suitable suspension point. The hook
5
lights up red. When charging is
3
lights up green. When the charging indicator
3
out of the socket. Disconnect the mains
10
.
6
on.
2
on and the inspection light
1
will turn off
2
, connect
10
can be
5