Assembly; Preparing Ingredients; Using The Appliance - Silvercrest SSM 200 A1 Bedienungsanleitung

Assembly

1) Remove all packaging materials and any stickers
from the appliance.
2) Clean the appliance as described in the section
"Cleaning and Care".
3) Place the motor unit
4) Push the blade roller
The drive shaft
of the roller housing
5) Screw the end cap
until the outlet
the end cap no longer turns. In doing so,
turn the end cap
6) Push the assembled roller housing
motor unit , so that the feed tube
offset (see Figure B on the fold-out page). The
locking mechanisms on the roller housing
must reach into the slots on the motor unit
Turn the roller housing
is facing upwards and the roller housing
snaps into place (see Figure C on the fold-out
page).
7) Place the pusher
NOTE
► The pusher lid
For removal:
–
Turn the pusher lid
allows itself to be removed.
For set up:
–
Place the pusher lid
so that both locking mechanisms on the
pusher lid slide through the slots on the
pusher and then turn the pusher lid
in clockwise direction so that it is firmly
held in place.
SSM 200 A1
on a flat surface.
into the roller housing
must project into the opening
.
onto the roller housing
is pointing downwards and
in clockwise direction.
into the
is slightly
, so that the feed tube
into the feed tube
can be removed.
anticlockwise until it
on the pusher
8) Insert the plug into a mains power socket.
The appliance is now ready for use.

Preparing ingredients

CAUTION! MATERIAL DAMAGE!
► Do not process fruits with stones or cores.
.
► Do not process whole nuts.
► Do not process ice cubes.
,
♦ Peel fruits such as bananas or kiwis.
♦ Remove cores, stones or stems from the fruit.
♦ Cut the fruit into small pieces so that it will easily
fit through the feed tube
♦ Ingredients such as such as cooking chocolate
must be crushed into small pieces.
.
♦ Put the prepared fruit in freezer bags or plastic
tubs and place them into the freezer for approxi-
mately 24 hours (-18°C).
NOTE
► Instead of freezing fresh fruit, you can use fruit
.
that has already frozen from the deep-freezer.

Using the appliance

1) Take the fruits out of the freezer about 10–
20 minutes before use.
2) Place a suitable bowl under the outlet
3) Remove the pusher
,
4) Add the prepared fruits into the feed tube
5) Switch on the appliance using the on/off
switch
.
from the feed tube
(position I).
GB │ IE
.
.
.
│ 15 ■