Charging External Devices - Silvercrest SRWK 800 A1 Bedienungsanleitung

Charging external devices

The radio alarm clock has a charging function that you can use to
charge the batteries of devices that are usually charged via a USB
connection . The maximum charging current is 1 .0 A .
NOTE
► The USB connection
devices .
► The charging function is not available during radio operation .
To charge an external device via the USB connection
radio alarm clock must be in standby mode .
► The radio alarm clock must be connected to the mains to charge
external devices .
► You can purchase a suitable USB charging cable (not supplied)
in any consumer electronics shop .
♦ Insert the USB-A connector of the USB charging cable into the
USB connection
♦ Insert the other USB connector of the USB charging cable into the
USB connection of the external device .
♦ The external device will start charging after a few seconds .
♦ After charging the external device, disconnect the USB charging
cable from the USB connection
■ 58 │ GB │ IE
is only intended for charging external
e
of the radio alarm clock .
e
e to
disconnect the devices .
, the
e
SRWK 800 A1