Troubleshooting - Klarstein 10033240 Bedienungsanleitung

EN
24

TROUBLESHOOTING

Problem Possible Cause
a) The red point of the knob of
thermostat is set "0".
b) The power plug was not
plugged in.
c) There is no power in the
socket.
d) There are problems with
electronic parts or sensors.
Cooling does
e) The heater does not function
not work, the
properly or is damaged.
cooling system
on back of the
refrigerator is
cool.
f) The refrigerator is at defrost.
g) The refrigerator is not
positioned correctly.
Possible Solution
a) Set the red point of the knob
of thermostat to the middle
position.
b) Put the plug in.
c) Check the power cord,
have the socket and power
lines checked by a qualified
technician, or use a different
socket.
d) If necessary, have electronic
parts and sensors checked and
replaced by the manufacturer or
a qualified technician.
e) If necessary, have the
heater bar replaced by the
manufacturer or a qualified
technician.
Note on replacement:
Unplug the plug, lift the
insulated tube 30 to 40 mm
untill you see the clip for the
heater bar and loosen the
heater bar.
Put the insulated tube to
its original position after
replacement.
f) Read the instructions for
automatic defrosting in the
„Operation" section of this
manual.
g) Turn the refrigerator 90° to
the front.