Hints On Disposal - Klarstein 10030521 Handbuch

EN
26
TROUBLESHOOTING
Problem
Ingredients stuck in the
pump.
Failing to reach 100 °C.
Temperature correction.
ERR-1 shown on display.
ERR-2 shown on display.

HINTS ON DISPOSAL

According to the European waste regulation 2012/19/EU this
symbol on the product or on its packaging indicates that this
product may not be treated as household waste. Instead it should
be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of
this product. For more detailled information about recycling of
this product, please contact your local council or your household
waste disposal service.
Possible cause and suggested solution
Flush the pump by connecting a hose to the curve pipe.
Dismantle the pump to remove the ingredients.
Put cover on for 1 to 2 mins.
Do temperature correction.
Do temperature correction. Press „-" and „+" at the
same time enter into C1 temperature correction setting.
Setting range is from -10°C to +10°C (or -50 °F. to
+50 °F, respectively). Press Temp button to confirm the
setting and exist the temperature correction page
Temperature is lower than -20 °C, it is low temperature
warning.
Senor connector is loosen.
Open the underneath and check the sensor. Re-connect
it if loosen.
Temperature is higher than 120 °C, it is overheat/boil-
dry warning.
Sensor is failure, please contact dealer for replacement.