Intended Use; Installation; Maintenance And Cleaning - Oase LunAqua Classic series Gebrauchsanleitung

Intended use

Lunaqua Classic LED Set may only be used as follows:
· For use in water fountain systems and ponds.
· For use above and under water.
· Operate in accordance with instructions.

Installation

The unit is supplied fully assembled as a complete set with a transformer and one or three LED spotlights, including
bulbs.
Installation (B-C)
· The foot can either be stood on the ground or bolted to a firm base or load bearing wall (B).
· Position the unit in such a way that it does not present a hazard to anybody.
· Adjust the tilt of the light (C, 1) and fix it at this angle with the screw connection (C, 4).
· Connect the plug of the spotlight connection cable to the socket on the transformer and tighten the union nut (C, 5)
hand-tight.
Commissioning/start-up
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical components.
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
· Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
· Isolate the device (disconnect from the power supply) before carrying out any work on it.
Switching on: Insert the power plug of the transformer into the socket.
· Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.

Maintenance and cleaning

W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
· Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
· Isolate the device (disconnect from the power supply) before carrying out any work on it.
· Ensure that no moisture can enter the unit.
Cleaning the device
If necessary, clean the unit with clear water using a soft brush.
Replacing the bulb (D)
· Unscrew the threaded ring (6).
· Remove the glass pane (7) and O ring (8) and check for damage. Replace if necessary.
· Remove the defective bulb (9) from the housing (1).
· Insert a new bulb (do not touch with your hands, use a cloth or similar).
Only use original bulbs from OASE. Light bulb rating: max. 1,3 W.
· Reassemble the unit in the reverse order. Ensure that the O ring (8) is correctly positioned.
· Reconnect to the power supply and check the function.
- EN -
9