Philips Saeco Xelsis SM7581 Benutzerhandbuch Seite 17

Problem
I cannot insert the brew
group.
The coffee is watery.
The coffee is not hot
enough.
Coffee does not come
out or coffee comes out
slowly.
The milk does not froth.
Cause
The brew group is not in the
correct position.
The brew group is dirty or
needs to be lubricated.
The grinder is set to a too
coarse setting.
The coffee settings have been
adjusted.
The machine is performing its
self-adjustment procedure
after a change in grinder
settings or bean types.
The cups you use are cold.
The temperature is set too low.
Check the menu settings.
You added milk.
The AquaClean filter was not
prepared properly for
installation or it is clogged.
The grinder is set to a too fine
setting.
The brew group is dirty.
The coffee dispensing spout is
dirty.
The machine circuit is blocked
by limescale.
The internal cappuccinatore is
dirty or not inserted correctly.
Solution
Reset the machine in the following way:
place back the drip tray and the coffee
grounds container. Leave the brew
group out. Close the service door and
switch the machine on and off. Then put
the brew group in the correct position
and reinsert it into in the machine.
Clean and lubricate the brew group.
Set the grinder to a finer (lower) setting.
Select your coffee drink and adjust the
settings to a stronger coffee.
Brew a few cups of coffee.
Preheat the cups by rinsing them with
hot water.
Set the temperature to 'high' in the
menu.
Whether the milk you add is warm or
cold, it always decreases the
temperature of the coffee to some
extent.
Remove the AquaClean filter and try to
brew a coffee again. If this works, make
sure the AquaClean filter is prepared
properly before you place it back. Place
back the prepared filter. If this still does
not work, the filter might be clogged
and needs to be replaced.
Set the grinder to a coarser (higher)
setting.
Clean the brew group.
Clean the coffee dispensing spout and
its holes with a needle.
Descale the machine.
Clean the internal cappuccinatore and
make sure that you position and insert it
correctly (see 'Cleaning the internal
cappuccinatore under the tap').
English
17