Maintenance And Cleaning; Kompernass Handels Gmbh Warranty - Parkside PFS 710 D3 Originalbetriebsanleitung

Plunge sawing:
CAUTION! RISK OF KICKBACK!
■ Plunge cuts may only be made in soft
materials (wood or similar).
Proceed as follows:
1. Place the sabre saw with the lower edge of the
footplate onto the workpiece. Switch the
appliance on.
2. Tilt the sabre saw forwards and plunge the saw
blade into the workpiece.
3. Position the sabre saw vertically and continue
sawing along the cutting line.

Maintenance and cleaning

WARNING! RISK OF INJURY!
Always switch the appliance off
before carrying out any work on it.
■ Always remove the power plug from the power
socket before cleaning the appliance.
■ Replace the saw blade as soon as its teeth are
blunt and proper sawing is therefore no longer
possible.
■ Keep the appliance and ventilation slits clean at
all times. If the ventilation slits are blocked, there
is a risk of overheating and/or the appliance
being damaged.
■ Always clean the appliance after completion
of work.
■ Never permit liquids to enter inside the appli-
ance. Use a cloth to clean the housing. Never
use petrol, solvents or cleansers which can
damage plastic.
■ If necessary, clean the saw blade mount with a
brush or compressed air.
PFS 710 D3
Kompernass Handels GmbH
warranty
Dear Customer,
This appliance has a 3-year warranty valid from
the date of purchase. If this product has any faults,
you, the buyer, have certain statutory rights. Your
statutory rights are not restricted in any way by the
warranty described below.
Warranty conditions
The validity period of the warranty starts from the
date of purchase. Please keep your original receipt
in a safe place. This document will be required as
proof of purchase.
If any material or production fault occurs within
three years of the date of purchase of the product,
we will either repair or replace the product for you
at our discretion. This warranty service is dependent
on you presenting the defective appliance and
the proof of purchase (receipt) and a short written
description of the fault and its time of occurrence.
If the defect is covered by the warranty, your product
will either be repaired or replaced by us. The repair
or replacement of a product does not signify the
beginning of a new warranty period.
Warranty period and statutory claims for
defects
The warranty period is not prolonged by repairs
effected under the warranty. This also applies to
replaced and repaired components. Any damage
and defects present at the time of purchase must
be reported immediately after unpacking. Repairs
carried out after expiry of the warranty period shall
be subject to a fee.
GB 7 ■
│