Technical Inspections And Scheduled Maintenance; Daily Inspection - Kärcher Futuretech 1.908-059.0 MFK Betriebsanleitung

Gas Burner
(2) Varnish sealing/preserving
For varnish sealing/preserving, only use agents that contain Carnauba or synthetic waxes.
Whether sealing/preserving of the coating is required can be recognized when water no
longer drips off.
(3) Touching up coatings
Minor coating defects can be touched up with spray paint or a touch-up applicator.
Rock damage or scratches are to be touched up immediately to prevent rusting.
Derust and clean minor coating defects where rust has already formed. Apply a base coat
(primer) and allow to dry well before applying the top coat. Polish up and seal/preserve the
touched-up locations/spots after a few days.
4.2

Technical Inspections and Scheduled Maintenance

4.2.1

Daily Inspection

Abbreviations:
b Before operation
d During operation
a After operation
Ser. No. Inspection Location
1 Gas burner
2 Flame control
3 Electronic igniter
4 Control valve
14
Check/Activity
• Check exterior condition
• Tight seating of the gas burner in the frame
• Check high-pressure hose for:
Condition, tight seating, tightness
• Check function:
Press operating push-button
Specification: Push-button must run freely
• Check function:
Specification: Ignition spark flashes over to burner
head
• Funktion prüfen:
Operating push-button must run freely on the opera-
ting panel
Specified value: 180° rotatable
Required clearance: 1.5 mm
SERVICE AND SCHEDULED MAINTENANCE
b d a
X X
X X
X X
X X
X X
X X X
X X X