Additional Safety Instructions; Noise And Vibration - Flex BME 8-4 Originalbetriebsanleitung

When working, guide the electric power

tool with both hands. The handle must be
attached! Do not switch on the machine
until both hands are in the grip position.
Keep hands away from the running

sanding belt. There is a risk of injury
caused by crushing in the area of the
guide rollers. On account of the operating
mode and the guaranteed flexibility of the
power tool these danger areas cannot be
completely shielded.
Dust released from materials, such as lead

paints, some types of wood, minerals and
metal, may be hazardous to the operator or
people in the vicinity. Inhaling or touching
these dusts may result in respiratory
diseases and/or allergic reactions.
– Ensure the work place is well ventilated!
– If possible, use external dust extraction.
– It is recommended to wear a respirator
mask belonging to filter class P2.
Do not work on materials which release

hazardous substances (e.g. asbestos).
Never grind or cut light metals which have

a magnesium content greater than 80%.
Risk of fire!
If power tools are used outdoors or are

exposed to excessive amounts of metal
dust, connect them via a residual-current-
operated circuit-breaker (tripping current
maximum 30 mA). Do not use any worn,
torn or severely clogged sanding belts.
Damaged sanding belts may rip, fly off and
cause an injury.
Before using the machine, check that the

grinding tools have been installed and
secured correctly. Switch on the machine
at no load for 30 seconds!
Interrupt the test run immediately if violent

vibrations occur or other damage is estab-
lished. Check the machine to determine
the cause.
Do not place the power tool under such

load that it comes to a halt or the sanding
belt slips.
Before putting down the power tool, switch

it off and wait until it comes to a standstill.
Do not clamp the power tool in a vice.

22
TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4
Always lay the power cord to the rear away

from the electric power tool.
Clamp the workpiece if it is loose or not

positioned securely by its own weight.
Store and handle grinding tools according

to the manufacturer's instructions.

Additional safety instructions

Use only extension cables permitted for

outdoor use.
Identify the power tool with stickers only.

Do not drill any holes into the housing.
The mains voltage and the voltage

specifications on the rating plate must
correspond.

Noise and vibration

NOTE
Values for the A-weighted sound pressure
level and for the total vibration values can
be found in the "Technical specifications"
table.
The noise and vibration values have been
determined in accordance with EN 60745.
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given
in EN 60745 and may be used to compare
one tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase
the exposure level over the total working
period.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly decrease
the exposure level over the total working
period.