Connecting The Antenna; Power Supply; Channel Selection Switch; Preparing Evolution 4000 For Video Transmission - MSA Evolution Anleitung

GB

3.1.3 Connecting the antenna

Plug the antenna cable with the 6-pole plug into the "Receiver"
socket on the LCD operating panel.

3.1.4 Power supply

Two mains cables (EURO, GB) and a motor vehicle connection
cable are available for the electrical supply.
The appropriate mains cable is plugged into the associated
socket of the LCD operating panel and the "power" switch is
switched on.

3.1.5 Channel selection switch

Set the channel selection switch in the LCD operating panel to
"channel 1". As described below a suitable setting up proce-
dure must be carried out on the camera transmitters. Automatic
tuning between the receiver and transmitter is not carried out.
In the event of disturbances on channel 1 or in the event of the
use of a second transmitter a changeover can also be made to
channel 2.
In the process channel 2 must likewise be set up at the trans-
mitter.
GB
3.2 Preparing EVOLUTION 4000
for video transmission
Switch on the camera in accordance with the operating instruc-
tions.
Switch on video transmission. The channel selected on the
camera must be the same as selected on the receiver unit.
The selected channel is indicated in the camera in the LCD
display on the right at the top.
3.3 Preparing EVOLUTION 5000
for video transmission
Switch on the camera or transmitter in accordance with the
operating instructions. The channel selected on the camera
must be the same as selected on the receiver unit.
Radio transmission takes place via channel 1 if one LED on the
transmitter lights. A change to channel 2 can be made by briefly
pressing the button - in this case 2 LEDs light.
13