Instructions For Charging The Battery; Maintenance And Cleaning - brennenstuhl LB 3000 Bedienungsanleitung

Mount the emitter on a tripod
The emitter can be mounted on a suitable tripod using the holes on
the bracket (mounting material not included in the scope of delivery!). Make sure the tripod is stable and
D
the emitter is firmly mounted.
Switching the emitter on/off
Press the button to turn the emitter on. The emitter will light up with 50% brightness.
E
To switch on the maximum brightness (100%), press the button again.
E
Please note:
When selecting 50%, the service life of the lamp extends in comparison to the 100% setting
as it consumes less energy. To switch it off, press the button again.
E
When the battery is almost empty, the LED emitter will blink 5 times. Then, the emitter will
remain lit at 50% brightness for approx. 10 minutes before the deep discharge protection switches
the emitter off. This provides sufficient time to replace the battery or stop working.
After the battery-operated emitter automatically switches off, do not continue pressing the on/off switch.
The battery can be damaged.

INSTRUCTIONS FOR CHARGING THE BATTERY

Only use one of the chargers listed in the following.
Only these chargers are calibrated to the Li-Ion batteries used in your rechargeable battery light:
brennenstuhl professionalLINE Charger CB 1801
®
Bosch Charger AL 1820 CV Professional
Bosch Charger AL 1860 CV Professional
Note: The battery is delivered with a partial charge. To ensure the full capacity of the battery, fully charge the
battery in the charger prior to the first use. The Li-Ion battery can be charged at any time without reducing
its service life. Interrupting the charging process does not harm the battery. The Li-Ion battery is protected
against deep discharges by the "electronic cell protection (ECP)". If the battery is discharged, the rechargeable
battery light will be shut off by a circuit breaker.

MAINTENANCE AND CLEANING

If the battery is no longer functional, it must be replaced. The rechargeable battery light does not require
maintenance. The LED light source cannot be replaced. If necessary, replace the entire spotlight.
Switch the emitter off prior to cleaning. Clean the emitter regularly with a dry, lint-free cloth.
To remove dirt, a damp cloth can be used. Do not use any solvents, caustic cleaning agents, etc.
www.professionalline.com 9
021117 BA_proLINE Akku SMD-LED-Strahler 28 W.indd 9 09.06.17 16:24