Mounting the temperature station
and / or the outdoor sensor on a wall:
Note: You will require an electric drill and a
crosshead screwdriver for this step.
CAUTION! DANGER TO LIFE, RISK
OF INJURY AND MATERIAL DAMAGE!
Read the operating and safety instructions for
your drill carefully.
Take care that you do not hit electricity, gas
or water lines when you drill into the wall. If
necessary, check with a pipe and cable de-
tector before drilling.
Temperature station
Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a crosshead screwdriver, screw the
screw
Hang the temperature station by placing
the hanger
External sensor
Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a crosshead screwdriver, screw the
screw
16 GB/IE
DANGER TO LIFE!
27
into the dowel.
26
on the screw.
23
32
into the dowel.
31
into the drilled hole.
into the drilled hole.