Maintenance - MO-EL 766 Gebrauch Und Wartung

Avoid exposing skin to the rays of the appliance for distances
less than 50 cm.
Avoid exposing eyes to the rays of the appliance for distances
less than 2.70 m.
All users should be made aware of all aspects of operation and safety
and these instructions should be retained for reference.
Switch on heater (in the models that have the switch) and confirm
that emitter is operating. Ensure that the heater is aiming its warmth
into the target area by adjusting heater angles as necessary by us-
ing the adjustment device on the bracket, after you have loosed the
screws of the half rings (fig.6).
Do not use the heater directly near a bathtub, a shower, a swimming
pool. In unoccupied premises it is recommended that the heating
system is switched off and isolated from the electrical supply.

5. MAINTENANCE

Mo-El Fiore heaters contain no moving parts and therefore very little
maintenance is required other than to ensure that there is no exces-
sive build-up of dust/dirt on the reflectors or emitters as this can
cause overheating and premature emitter failure. To clean the appli-
ance, wipe off with a damp cloth.
The accumulation of limestone or incrustations reduces the life and
the efficiency of the lamp; it is suggested therefore to avoid the con-
tinued use in presence of water or salt fog. Eventual leavings of salt
water will have to be removed before the use, after having discon-
nected the appliance, by means of soak in sweet water.
6. EMITTER AND SILICON BUMPERS REPLACEMENT
The emitters used in the Fiore are robust and if knocks and shock
vibrations are avoided, they will last for around 5000 hours. When
changing the lamp, also the silicon bumpers connected with the
lamp must be substituted. They should be substituted even before
if there are signs of aging. Due to the special sealing and anti-shock
design of the heater, the emitters are not intended to be user re-
placeable. Please ensure that all emitters are replaced via the Mo-El
service network.
12