STIEBEL ELTRON WPE-I 33 H 400 Premium Bedienung Und Installation Seite 85

INSTALLATION
Appendix
Message
Heating circuit 2 control
Heating circuit 3 control
Heating circuit 4 control
Heating circuit 5 control
WCS control
Cooling circuit flow control
Cooling control
Control, surplus heat
Room temperature sensor
External alarm
Low system flow temperature
High system supply temp.
Error comm. to primary
Error comm. to secondary
Too few secondary pumps found
Secondary pump class A
Secondary pump class B
Alarm, ext. heat pump pressure switch
Ext. heat pump general error
Ext. heat pump communication
www.stiebel-eltron.com
Class Description
C Temperature deviation in accordance with alarm settings for distributor circuit 2
C Temperature deviation in accordance with alarm settings for distributor circuit 3
C Temperature deviation in accordance with alarm settings for distributor circuit 4
C Temperature deviation in accordance with alarm settings for distributor circuit 5
C Temperature deviation in accordance with alarm settings for WCS
C Temperature deviation in accordance with alarm settings for cooling
C Temperature deviation in accordance with alarm settings for cooling cylinder
C Temperature deviation in accordance with alarm settings for surplus heat
C Room sensor communication error
C Alarm input for external alarm; activation in the menu "Alarm control/central alarm" menu is
required
C Flow temperature below 70 % of the set value for longer than 3 hours
C Flow temperature exceeds the specified limit value (standard: 70 °C)
D Communication error secondary to primary heat pump
D Communication error primary to secondary heat pump
D The number of secondary heat pumps communicating with the primary heat pump is less than
expected
D A secondary heat pump reacting to a class A alarm
D A secondary heat pump reacting to a class B alarm
E Operating pressure switch for extension module
E Central alarm from secondary heat pump
E Communication error extension module (to primary heat pump)
WPE-I H 400 Premium | 85