Reset Button; Hardware Installation - LevelOne WAC-1001 Schnellstartanleitung

Ports
Port
LAN
WAN
USB
TF Port

Reset Button

If you forget the administrator password, you can use the Reset button to reset the device to factory default
settings. The operation is as follows: With the device powered on, press and hold the Reset button for more
than 5 seconds, and then release the button. The device will restart with factory default settings.
Note :
The reset operation will clear all custom settings on the device, please do it with caution.

Hardware Installation

Please follow the steps mentioned below to install the hardware:
1.
Connect the Device to the local network.
Connect one end of an Ethernet cable to one of the LAN ports on the Device, and the other
end to a network port on a PC, hub, switch or wireless access point. Repeat this step to
connect more PCs or other network devices to the Device.
2.
Power on the Device.
Before you power on the Device, make sure that the power supply is normal and well
grounded.
Now, the hardware installation is completed.
Description
The LAN ports connect computers and other Ethernet network devices to the
LAN.
The WAN port connects the device to the Internet.
The number of WAN ports depends on the device model.
You can connect a USB disk to store firmware and configuration files.
You can connect a TF disk to store firmware and configuration files.
4