Installing The Rear View System; Tools Required - Waeco PerfectView CAM26W Montage- Und Bedienungsanleitung

_RV-HD-STANDARD.book Seite 47 Montag, 28. November 2005 3:46 15
PerfectView
7.3 Creating clean soldering joints
Proceed as follows to solder a cable to the original cables:
➤ Strip approx 10 mm of insulation from the end of the original cable (d A,
page 7).
➤ Strip approx 15 mm of insulation from the end of the cable to be
connected (d B, page 7).
➤ Wrap the cable to be connected around the original cable and then
solder the two cables together (d C, page 7).
➤ Insulate the two cables with insulating tape (d D, page 7).
Proceed as follows to solder two cables together:
➤ Strip the insulation from both ends of the cables (e A, page 7).
➤ Slip a shrink sleeve with a length of approx. 20 mm over the cable (e B,
page 7).
➤ Twist the cables together and solder them together (e C, page 7).
➤ Slide the shrink sleeve over the soldered joint and heat it gently (e D,
page 7).
8

Installing the rear view system

8.1

Tools required

For installation and assembly you will require the following tools:
Drill bit set (1 1, page 3)
Drill (1 2, page 3)
Screwdriver (1 3, page 3)
Set of ring or open-ended spanners (1 4, page 3)
Measuring ruler (1 5, page 3)
Hammer (1 6, page 3)
Centre punch (1 7, page 3)
Installing the rear view system
47