For Your Safety; Device Components - Würth PNG 102 Bedienungsanleitung

GB
Safe working with the welding
machine is only possible if the
operator has read these oper-
ating instructions and fully un-
derstands and adheres to the
safety instructions in this docu-
ment.
While the tool is in operation, all
persons at the workplace must wear
suitable hearing protection and pro-
tective goggles. If no hearing pro-
tection is worn, the sound pressure
level of the tool can cause damage
to the hearing.
There is a risk of sparking and pro-
pelled parts that can cause damage
to unprotected eyes.
Wear protective goggles and
safety footwear.
Risk of explosion!
Do not use oxygen, flammable or
bottled gases to power the tool!
Otherwise, there is a risk that the
tool might explode, causing serious
injury or even death!.
Before using the tool, the operator must familiarise himself with all device features and the applicable safety instruc-
tions.
Fig. I
1 Tip
2 Sleeve
3 Tension sleeve
4 Gripping jaws
5 Suspension eyelet
6 Oil filler screw
7 Oil filler tank
8 Waste collector
9 Rotating air deflector
8

For your safety

Use only original Würth accessories and
spare parts.

Device components

10 Trigger
11 Slide switch for vacuum suction
12 Pressure relief valve
13 Compressed air connection
14 Hydraulic oil bottle, 100 ml
15 Size 14/17 assembly spanner
16 Size 12/14 assembly spanner
17 Shut-off valve
Risk of injury from incorrect op-
eration!
It is forbidden to make any modifi-
cations to the machine or to attach
other components to it! Such modifi-
cations could cause injury to persons
or damage to the equipment.
Risk of injury from falling!
Do not use the tool when standing
on a ladder or unstable structure.
Always ensure that you are standing
on firm ground before starting the
machine.
Risk of injury!
Do not let the connected tool un-
supervised so as to prevent unau-
thorised use. When leaving the
workplace, always disconnect the
tool from the compressed air supply
system.
Caution
Operate the tool only with the pre-
scribed operating pressure. Never
connect the tool to compressors
that generate pressures greater than
13.8 bar. Incorrect pressure leads to
malfunction and causes damage to
the tool. (For recommended operat-
ing pressure, see technical data.)