Router Cage; Changing The Batteries; Cleaning, Care And Storage - Parkside PFBS 160 B2 Originalbetriebsanleitung

Router cage

With this attachment, the appliance is particularly suit-
able for cutting special forms (holes for plugs, etc.).
♦ Insert the milling bit
tion "Changing/inserting the tool/collet chuck".
♦ Ensure that the shaft of the bit protrudes out of
the collet chuck by about 13 mm.
♦ Screw the union nut
appliance and store it carefully.
♦ Unscrew the router cage
♦ To set the correct working height, undo the
locking screw and adjust the foot of the
router cage to the desired size.
♦ Afterwards, retighten the locking screw
│ GB │ IE │ NI
■ 14
as described in the sec-
anticlockwise off the
off the appliance.
.
ca. 13 mm

Changing the batteries

♦ Make sure that the LED light is turned off.
Remove the three screws from the rear of the
grip ring with LED
♦ Replace the used batteries in the appliance
with new batteries of the same type (button
cell LR41). Note polarity when installing new
batteries.
♦ Close the battery compartment again by re-
placing the three screws.

Cleaning, care and storage

WARNING! RISK OF INJURY!
■
Switch the appliance off and remove the
power plug before starting any work on
the appliance.
The appliance is maintenance-free.
■ Remove all dirt from the appliance. Use a dry
cloth to do this.
WARNING!
■ If the power cord requires replacement, this
should be carried out by the manufacturer or
an approved representative to avoid safety
hazards.
■ Store the appliance and all the individual piec-
es in the provided plastic case to ensure you do
not lose any part.
NOTE
► Replacement parts not listed (such as the
rechargeable battery, battery charger) can
be ordered via our service hotline.
WARNING!
■ Always ensure that the power plug or
the mains cable is replaced only by the
manufacturer of the appliance or by an
approved customer service provider. This
will ensure that the safety of the appliance is
maintained.
.
PFBS 160 B2