Grasslin talento taxxi Bedienungsanleitung Seite 18

Transferring switching programs to the time switch and vice versa
With the Prog. key, select the corresponding memory location P_1 .... P_4
• Transfer the contents or
• With a memory location
1. Hold the handheld programming device directly on the two IR diodes (hold
the handheld programming device still during this operation)
2. Press the corresponding key twice, depending on the transfer direction –
in or out
3. Press the key once.
The transfer is prepared and the relevant program location and the
Z Z
assignment in or out flash alternately
4. Press the key again. The data is transferred.
An audible signal is output during the transfer.
Z Z
If the data has been correctly transferred, the number of the program location, e.g. P_ 1, can be
Z Z
seen in the display (of the handheld programming device).
If the data has not been correctly transferred, there is a short, audible signal and the
Z Z
corresponding error message Er x appears in the display.
18