AniOne Keramik Trinkbrunnen Bedienungsanleitung Seite 34

REASSEMBLING AND RESTARTING YOUR FOUNTAIN AFTER CLEANING
1. Make sure that the motor fl ow rate lever is set to the maximum or "+" position (Figure 8).
2. Change the replacement fi lter (please replace any fi lter over four weeks old). If using a new replacement fi lter, fi rst rinse the fi lter before use.
3. Attach the replacement fi lter to the pump. Attach the clear tube to the water tube of the pump.
4. Reinstall the pump in the inside of the bottom bowl and press it down so that the suction cups attach to the bowl (Figure 9). Thread the power cord
through the hole at the back of the bottom bowl.
5. Please make sure that the upper end of the clear tube lines up with the water spout of the top bowl. Put the top bowl on (Figure 10).
6. Place the fountain in its desired location. The use of a protective mat is recommended to protect your fl oor from splashes or drips which may occur
when in use.
7. Fill the unit with approx. 2 litres of water.
8. Plug the power cord into the transformer.
9. Before you plug in the fountain, make sure both the cord and your hands are dry.
10. Add water as needed.
8 9 10
USAGE TIPS
When being introduced to the AniOne Ceramic Drinking Fountain Waterfall, your pet may be cautious about this new source of water. After putting
the fountain into operation, allow your pet to get used to it at his or her own pace. Some pets take a few days or sometimes a little longer to begin
using it.
Your pet may prefer the fountain to be placed away from their normal feeding area. Try plugging it in somewhere else, like the laundry room, ba-
throom or another corner of the kitchen. In some cases it may be necessary to let the fountain sit unplugged until your pet starts to drink. Later, you
can plug the fountain in so that the water maintains its freshness.
DO NOT RUN DRY!