Configuring The Unit; Unit Parameters - Carrier CCU Controller Bedienungsanleitung

C01 Number of units
C02
C08
C09

6 - CONFIGURING THE UNIT.

6.1 Unit parameters

6.1.1 UNIT TYPE (sub-menu 3.1)
To limit the amount of different software required whilst meeting our customers' need for applications, the CCU CONTROLLER is
provided with a configuration system. It allows the composition of the unit to be configured, along with all the functions which must
be managed by the system
To configure the CCU CONTROLLER, use the menu No.3: PARAMETER and the sub-menu No. 3.1: UNIT TYPE. (Menu on CCU
CONTROLLER display)
These parameters are directly linked to the composition of the unit, and they must not be modified on site.
The procedure for saving these parameters is carried out in the workshop. (To view the type of programming specific to your
control, refer to the configuration guide attached to the unit).
To modify parameters P01 to P99, the unit must be stopped and the configuration unlocked. Parameter P99 (Locking of
configuration) is equipped with a system which counts the number of times the configuration is unlocked.
Most of the parameters can only be modified if the correct authorisation level is accessed in Menu No.8 of the CCU CONTROLLER
(See paragraph 4 in this guide).
No additional
Additional
French
English
German
Spanish
Unlocked
Locked
EN - 12
C03
No backup
Backup
C04
One additional backup unit
C05
No rotation
Automatic rotation
The additional unit
acts as backup
One backup unit
Trigger setpoint
Rotation time delay