Connect The Cables - Axis YP3040 Installationsanleitung

Page 6
Splint dimensions
Mounting holes for housing (AXIS T92A)

Connect the cables

1. Connect the power supply to the pan-tilt motor according to the Installation Guide supplied
with the mains adaptor. The recommended mains adaptor is AXIS PS24 Mains Adaptor. For
more information on this product, see the Axis web site at www.axis.com
Power supply cable 24 V AC
2. Connect the PTZ control cable to the camera's RS-485 port. Different camera models have
different terminal connectors, be sure to follow the correct description for the installed camera.
The correct connector is supplied with the Axis network camera. For more information on Axis
network cameras, see the Axis web site at www.axis.com
PTZ control cable (RS-485)
3. Connect the camera to the network, see the Installation Guide provided with the camera.
Note:
The RJ-45 connector for the network cable will not pass through the cable gland on the
underside of the AXIS T92A20. The cable must be cut, threaded through the cable gland and
then re-crimped.
122 mm (4.8 in.)
Ø 6 mm (0.2 in.)
Wire color
Red
Red
Yellow/green
Wire color
Red
Blue
YP3040 Installation Guide
Connect to
24 V AC on power supply
24 V AC on power supply
GND
Connect to
A+ on camera
B- on camera