AEG A61900HLW0 Benutzerinformation Seite 26

26 www.aeg.com
Problem
Audible or visual alarm is on. The cabinet has been re-
Power indicator light is flash-
ing.
The lid doesn't close com-
pletely.
The lid is difficult to open.
The lamp does not work.
The compressor operates
continually.
Possible cause
cently switched on or the
temperature in the appli-
ance is too high.
An error has occurred in
measuring the temperature.
The appliance is not working
properly.
The lid gaskets are dirty or
sticky.
There is excessive frost.
Food packages are blocking
the lid.
The lid gaskets are dirty or
sticky.
The valve is blocked.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrect-
ly.
Large quantities of food to
be frozen were put in at the
same time.
The room temperature is too
high.
Food placed in the appli-
ance was too warm.
The lid has been opened too
frequently.
The lid is not closed proper-
ly.
Solution
Refer to "Door Open
Alarm"or "High Tempera-
ture Alarm" and if the prob-
lem still occurs contact a
qualified electrician or con-
tact the nearest Authorized
Service Centre.
Contact a qualified electri-
cian or contact the nearest
Authorized Service Centre.
Contact a qualified electri-
cian or contact the nearest
Authorized Service Centre.
Clean the lid gaskets.
Eliminate excess frost.
Arrange the packages in the
right way, see the sticker in
the appliance.
Clean the lid gaskets.
Check the valve.
Close and open the door.
Refer to "Replacing the
lamp".
Refer to "Operation" chap-
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food to cool to room
temperature before storing.
Do not leave the lid open
longer than necessary.
Check if the lid closes well
and the gaskets are undam-
aged and clean.