Accessories; Technical Data; Circular Saw - Hilti SCM 22-A Originalbetriebsanleitung

Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.4 Fence
Use of the single arm fence allows precise cuts to be made along the edge of the workpiece, or strips of
even width to be cut.
The fence can be fitted on either side of the base plate.
3.5 Items supplied
Circular saw, saw blade, hex key, fence, operating instructions.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group.
3.6

Accessories

Clamping flange, mounting flange, clamping screw.
4

Technical data

4.1

Circular saw

Rated voltage
Weight in accordance with EPTA procedure 01
Saw blade diameter
Blade disc thickness
Kerf width
Saw blade arbor size
Rated speed under no load
Maximum cutting depth
Operating temperature
Storage temperature
4.2 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.3 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
22 English
Printed: 06.06.2019 | Doc-Nr: PUB / 5142664 / 000 / 04
SCM 22-A
21.6 V
4.1 kg
160 mm ... 165 mm
1.2 mm
1.6 mm
20 mm
3,500 /min
57 mm
−10 ℃ ... 50 ℃
−30 ℃ ... 70 ℃
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
2019522
*2019522*