Videotec VIPNX Bedienungsanleitung Seite 5

6.1.2 Installing the wiper kit on NXJ
housing
Position the wiper under the housing so that slots on
the body correspond with the fastening pins.
Fig. 02
Fasten the wiper body to the housing by screwing
the nuts onto the fastening pins.
Assemble the wiper blade on the output shaft, fixing
it in the rest position on the left side of the glass front.
Fig. 03
6.1.3 Installing the wiper kit on NXL,
NXM and NXM36 housing
Insert the open metal fastening band through the 2
slots on the wiper body as shown in the drawing.
Fig. 04
Position the wiper body (Fig. 3) by passing the band
round the housing body.
Tighten the band with a screwdriver, locking the
wiper body.
Fig. 05
Assemble the wiper blade on the output shaft, fixing
it in the rest position on the left side of the glass front.
Fig. 06
If necessary adjust the fastening band to set the
position of the wiper body so that it does not
interfere with the housing support. In this way
assembly is adaptable to the orientation of the
housing.
Pay attention to the adjustment of the
j
wiper blade in the housing NXM36. The
movement of the wiper blade must not
interfere with the heads of the screws.
Fig. 07
3