Using The Appliance - Sinbo SSI 2885 Bedienungsanleitung

USING THE APPLIANCE

Filling the water into detachable water tank
Make sure that there is enough water in the water tank. (Fig.2)
Note: Don't put hot water, perfume, vinegar, starch, descaling agents, ironing aids or other
chemicals in the water tank.
1. Remove the detachable water tank from the steam generator. (Fig.1)
Note: Detach the water tank and fill it at any time during use.
2. Fill the water tank with tap water up to the MAX indication.
Note: If the water in your area is very hard, we advise you to mix it with an equal amount of
distilled water.
3. Slide the water tank back into the steam generator. (Fig.3)
4. Make sure that the water tank is firmly attached to the steam generator.
Note: Don't tilt or shake the steam generator when the water tank is full, otherwise water may
spill out of the filling hole.
Note: Fill the water tank before first use and as soon as the 'no water alarm' indicator is on.
No water alarm indicator
When the water tank is almost empty, the 'no water alarm' indicator(M-2) is on and steam
ironing is no longer possible.
1. Shut off the power switch.
2. Remove the water tank and fill it.
3. Put the water tank back into the steam generator till its clicks place, the iron is ready for
steam ironing again.
Dry ironing function
1. Place the steam generator on a stable and level surface, e.g. on the hard part of the ironing
board or on a table.
2. Put the mains plug in an earthed wall socket and press the on/off button to switch on the
steam generator?the dry iron function is on normally, the dry iron indicator (M-1) is on at the
same time?and you can dry iron after 2 minutes.
Boiler heating function and Steam ironing
1. Place the steam generator on a stable and level surface, e.g. on the hard part of the ironing
board or on a table.
2. Put the mains plug in an earthed wall socket and press the on/off switch (on the control
panel), the 'dry iron' indicator starts flashing(M-1), press the boiler heating button(M-7) to shift
to steam ironing( The 'dry iron' stop flashing ), the boiler heating indicator(M-4) starts flashing.
After 2.5 minutes, the steam ready indicator (M-3) flashes, it shows that the steam is ready.
Note: If you want to shift from 'boiler heating' to 'dry iron', you press the 'boiler heating' button
again, then the 'boiler heating' indicator and 'steam ready' indicator turns off, the 'dry iron'
indicator is on, the dry iron is ready.
3. To set the required ironing temperature, turn the temperature dial to the appropriate position.
(Fig.4)
4. Turn the power knob to the desired steam setting to switch on the appliance. Make sure the
steam setting is suitable for the selected ironing temperature. (Fig.5)
5. Press the steam trigger(C) and keep it pressed while you steam iron. (Fig.6)
- 10 -