Danger Of Fire - Futurelight DMH-75 Infinity Bedienungsanleitung

The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The projector should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the projector. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The projector has to be installed out of the reach of people.
If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to be
used. The projector must never be fixed swinging freely in the room.
Caution: Projectors may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Follow the instructions mentioned at the bottom of the base.
the structure (truss) to which you are attaching the fixtures is secure.
The fixture's base enables to be mounted in two ways.
latest industrial safety regulations (e. g. BGV C1, BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!

DANGER OF FIRE!

Use appropriate clamps to rig the fixture on the truss.
Make sure that the device is fixed properly! Ensure that
The Moving-Head can be placed directly on the stage floor or rigged in any
orientation on a truss without altering its operation characteristics (see the
drawing).
For overhead use (mounting height >100 cm), always install an appropriate
safety bond.
You must only use safety bonds complying with DIN 56927, quick links
complying with DIN 56927, shackles complying with DIN EN 1677-1 and
BGV C1 carbines. The safety bonds, quick links, shackles and the carbines
must be sufficiently dimensioned and used correctly in accordance with the
CAUTION!
36/54 00081673.DOC, Version 1.0