Auto Mode (Automatic); Night Function; Timer Mode; Programmed Switching On - Olimpia splendid DOLCECLIMA COMPACT Handbuch Für Installation, Gebrauch Und Wartung

3.8 - AUTO MODE (Automatic)

a. this mode can be selected by pressing B2 or SW2 until the automatic symbol (auto) is displayed on
the remote control.
b. in this mode, the CoolinG and fan functions are selected automatically depending on the continuously
monitored room temperature value to ensure that there is a perfect comfort-level in the conditioned room.

3.9 - NIGHT FUNCTION

a. this mode can only be selected from the remote control (by pressing B11) and can only be used in con-
junction with cooling and automatic modes.
b. When this mode is enabled, the internal fan is forced to run at automatic speed and the set room temper-
ature is automatically increased by 1°C after 1/2 hour and by another 1°C again after 1/2 hour (starting
from function activation and consequent modification of the set temperature).
c. after 7 hours the initial temperature is automatically restored.
d. When the set temperature is modified from the remote control, when the appliance is placed in standby,
or when the power supply is disconnected, the night function is disabled.
e. to deactivate the function press the B11 button again.

3.10 - TIMER MODE

a. This mode allows to program the switching on or the switching off of the appliance.
b. the delay time can be set by the remote control.
3.10.a Programmed switching on
Select the operating mode, the desired temperature and the ventilation speed with which the unit will
activate automatically as programmed.
a. By pressing B7, set the desired time delay (from 0.5 to 24 hours) after which the unit will switch on (starting
from timer confirmation).
if no button is pressed within 5 seconds the timer setting function will terminate automatically.
b. When the delay time set has elapsed, the unit switches on with latest selected settings.
c. to cancel the delayed power-on, press button B7 again until a value of 0 is set.
d. When the timer is active, symbol S2 is activated on the machine and symbol 7 on the remote control.
3.10.b Programmed switching off
a. With the unit in any working mode, press B8 to set the desired time delay (from 0.5 to 24 hours) after
which the unit will switch OFF (starting from timer confirmation).
each following B8 key operation increases the delay time value by 1 hour.
b. if no button is pressed within 5 seconds the timer setting function will terminate automatically.
>>>>>
EN - 25
DOLCECLIMA COMPACT