Initial Setup - IKEA UPPLEVA 24 Bedienungsanleitung

Important:
Batteries shall not be exposed to excessive
heat such as sunshine, fire or the like. If
the batteries in your remote control are
run down you can use the buttons on your
TV set. In TV mode, they have the same
functions as the corresponding buttons on
the remote control. In the menus they have
the following functions:
CH
CH
VOL
VOL
MENU/
OK/
Switch the TV on and off
1. When powered on, the TV will be turned
on directly or be in standby mode. If
the TV is in standby mode, press the
or POWER/ button on the set or the
button on the remote control to turn
it on.
2. To put the TV into standby mode, press
the or POWER/
the button on the remote control. The
TV set remains powered up, but with low
energy consumption.
3. To switch off the TV, unplug the mains
socket from the mains outlet.
(*On certain models, you have to turn on
the power switch first.)
MENU
OK
button on the set or

Initial setup

Initial setup involves selecting all the
settings required to be able to search for
and store all the analog and digital channels
you can receive.
Make sure that the television is switched
on and follow all the steps in turn specified
hereafter.
Note: If the channel search retrieved only
the analog channels it could be caused
by poor broadcasting and therefore is
not covered by manufacturer warranty.
Manufacturers cannot be held responsible
for lack of or poor broadcasting in some
areas.
The first time you switch the set on, the
Initial Setup wizard opens, which guides
you through the initial setup process. (Refer
to Figure 1.) Press OK to start your initial
setup.
1. Press / to select your language, then
press OK/ to enter the next step.
2. Press / to select your country, then
press OK/ to enter the next step.
Note: If you select France, you will
have to enter the Password Setting
menu here in order to set a password.
Use the digit buttons to enter a four-
digit number for your password. (0000 is
too simple to be set as your password.)
Re-enter the same code to confirm the
password. After that, you will enter the
next step automatically. (In this step,
you can only press BACK to return to
the previous step.)
3. Press / to select your tuner mode Air
or Cable.

Select Air.
•
OK/ to enter.
Press
•
Press / to select Scan, then
press OK/ to automatically start
the search relating to initial setup
for all DVB-T digital and analog
channels.

Cable.
Select
•
Press OK/ to enter.
•
Press / to select Scan, then
press OK/ to directly start your
initial setup or enter below step.
•
Select Full if available to search
for and store all DVB-C digital and
analog channels.
•
You may select another advanced
scan mode if available (for example,
10