Initial Setup Wizard - IKEA UPPLEVA Handbuch

5 Initial setup wizard

The initial setup wizard starts automatically
the first time you switch on your TV (See
Figure 1). It will guide you through the
settings required for you to start using
your TV. If you want to change any of the
settings later you can easily do so in the
Options or Setup Menu. Use the
OK buttons to navigate and confirm your
settings. Follow the steps on the screen
with the help of the hints at the bottom of
the screen. You can always return to the
previous step by pressing . Press EXIT to
interrupt the initial setup wizard. Refer to
this manual if you need further explanation.
Note: If the channel search retrieved only
the analogue channels it could be caused
by poor broadcasting and therefore is
not covered by manufacturer warranty.
Manufacturers cannot be held responsible
for lack of or poor broadcasting in some
areas.
1. Select your language by using
Press OK to confirm and move on to the
next step.
2. Select your country by using
OK to confirm and move on to the next
step.
3. Select Home if you want to watch your
TV at home or select Store if the TV is
being installed in a store. Move on to the
next step.
4. Choose if you want to set up a network
connection or not by using
OK to confirm and move on to the next
step.
If you choose to set up a network
connection, follow steps 5-7. Otherwise skip
these steps and go to step 8.
Note: If you select France or Italy, you will
have to set a password for your network
connection. You will be automatically
forwarded to the Password setting menu.
Use the number buttons to enter a four-
digit number for your password. (0000 is
too simple to be set as your password.)
Re-enter it to confirm your password.
When finished, you will be automatically
transferred to the next step.
5. Use
6. To set up a wireless connection.
/ and
/ .
/ . Press
Note:
– This TV can memorise the available
networks so it can connect to the network
even if it has been powered off.
/ . Press
/ to choose between connecting
wirelessly (step 6) or via a network
cable (step 7). Press OK to confirm and
move on to the next step.
You can set up the wireless network
connection in 3 ways:
a) Scan. If you want to see and choose
from all the available networks within
range.
– Select Scan and press OK to start
scanning. The TV will search for and
display all the available networks.
– Navigate to the desired network and
press OK to connect the TV. If you
select a protected network, you will
have to enter the corresponding
password. Press OK on the remote
control to display the virtual keyboard
where you can enter the password.
Select OK to leave the virtual
keyboard and confirm the password
by pressing Next. If the connection
is successful, press
continue with the wizard. If it is not
successful, repeat this step.
b) Manual. If you want to search for a
specific network.
– Select Manual and press OK. You will
be asked to enter the correct name
(SSID) of the wireless router you
wish to connect to. If you select a
protected network you will have to
enter the corresponding password.
Press OK on the remote control to
display the virtual keyboard where
you can enter the password using
the / / / and OK. Select OK
to leave the virtual keyboard and
confirm the password by pressing
Next. If the connection is successful,
Next again to continue with
press
the wizard. If it is not successful,
repeat this step.
c) Auto. If your network supports WPS
(Wi-Fi Protected Setup).
– You can connect to the network via
PBC (Push Button Configuration) if
27
Next again to