Stop Watch Function - Silvercrest SWEP 500 A1 Bedienungsanleitung

GB
Set snooze time
• With the radio switched off, press the button
The screen displays the snooze time set (default is SNO 10).
UP
• Use the and
1 and 59 minutes.
Turning off the alarm function
Vol.+/AL–1
• Press the
disappear from the screen.

Stop watch function

The stop watch function is only available when the radio is switched off.
• Press and hold down the
shows 0.00 0 U.
SNOOZE
• Press
is 39 minutes and 59 seconds. If the stopwatch exceeds the maximum
time, the indicator 39:59.0 appears and flashes in the display.
• During time measurement, it can be stopped by pressing
SNOOZE
• Pressing
• Hold down
• Leave the stop watch by pressing
DOWN
buttons to set the snooze time to a time between
Vol.–/AL–2
or
PAGE
to start the stop watch. The maximum time for the stop watch
again restarts the stop watch.
SNOOZE
to reset the stop watch.
MODE
button until the relevant alarm symbols
button for around 2 seconds, the screen
PAGE
.
- 86 -
seven times.
SNOOZE
.