BaByliss E773XDE Bedienungsanleitung Seite 7

ENGLISH
KIT HAIR/BEARD + NOSE/
EAR CLIppERS E773XDE
1. 2 cutting guides for 22 lenghts
(from 3 to 18mm and from 21 to
36mm, in 1.5mm steps)
2. 1 precision guide
5 positions (0.5 to 2.5mm)
3. Blades:
Moveable blade:
- Sharpened using
process: for an exceptionally sharp
cutting edge.
- CMS
(Chrome-Molybdenum-
Stainless Steel): ultra-hardwearing
and 100% stainless steel blade.
Fixed Blade:
- Titanium coating: for longer life.
These two technologies
perfect surface condition and their
combination is optimal for reducing
the friction coefficient.
4. Thinning function
5. Turbo function
6. ON/OFF switch
7. Cutting length control knob
8. Lateral display
length
9. Charging indicator light
10. plug for use on the mains and
for charging
11. Cleaning brush and comb
IMpORTANT
REGARDING THE NI-MH BATTERIES
OF THIS UNIT
To obtain and maintain the longest
battery autonomy possible, allow
it to charge for 16 hours before
using it for the first time and then
approximately every three months.
Full autonomy of the unit will only
be obtained after three complete
recharge cycles.
3D etching
provide
of selected
INFORMATION
7
CHARGING THE CLIppER
Before using the clipper for the first
time, allow it to charge for 16 hours.
1. Connect the transformer to the
mains and the plug into the unit.
(Fig. 1)
2. Check that the charging indicator
light is lit and that the switch on
the clipper is in the OFF position.
3. A fully charged clipper will run for
30 minutes.
MAINS USE
Connect the transformer into the
mains, wait 1 minute and then
switch into the ON position.
IMPORTANT! Use only the transformer
provided with the E773XDE clipper
Voltage = 3.0V - Tension = 1000mA
TURBO
For an extra burst of power, push
the TURBO button on the top side
of the clipper. This will boost the
motor of your clipper, producing
faster cutting action and increased
cutting power for the more difficult
cutting tasks.
USING THE CUTTING GUIDES
Very practical, the cutting guide
guarantees equal cutting length.
IMPORTANT: Always
cutting guide BEFORE turning the
trimmer on, and turn it off before
changing the guide.
To attach the cutting guide, first
adjust the cutting length to 3mm or
21mm and place it on the support
guide adjusting first both sides and
then pushing on the bottom of the
guide until you hear a 'click' . (Fig. 2)
attach the