Testing The Installation - Hoover Novamatic WT 1408 E Bedienungsanleitung

40005533Eng.qxd 26/03/2008

Testing the installation

This
programme
will take
approximately
2 hours to
complete.
50
11:26 Page 50
Refer to the programme guide for details of how
to select programmes.
1. Turn on the water supply and check for leaks
from the fill hose.
2. Switch on the electricity supply.
3. Select the spin programme Low Spin
(Schleudern Tief/Essorage Bas) or High Spin
(Schleudern Hoch/Essorage Haut) and then
press the Start Pause (Départ Pause) button to
start the machine. Allow the programme to
continue for one minute and then cancel the
programme by returning the selector to the
OFF position. This will remove any water
remaining in the machine from factory
testing.
4. To check for cold water filling to the machine:
Select the rinse programme Rinse
(Spülen/Rinçage) or Extra Rinse (Extra
spülen/Rinçage extra) and press the Start
Pause (Départ Pause) button to start the
machine.
Allow the tumble action to continue until the
water has pumped out. Check that the drain
outlet is not leaking or overflowing.
5. Switch off the machine at the end of the cycle
by turning the programme knob to the OFF
position.
6. Select the spin programme Low Spin
(Schleudern Tief/Essorage Bas) or High Spin
(Schleudern Hoch/Essorage Haut) and press
the Start Pause (Départ Pause) button to start
the machine. If the machine takes longer
than one minute to empty check the drain
hose for kinks.
Installation testing is now
complete.
Now you have successfully installed the machine
we advise that you run the machine to ensure the
drum is thoroughly clean after testing and storage.
Select the Cottons (Baumwolle/Coton) 90
programme and run the machine for a complete
cycle using only wash detergent and water. Ensure
that the drying timer is in the OFF position.