Installation; Preparing For Use; Preparing The Machine For Use; Using The Machine For The First Time Or After A Period Of Inactivity - Saeco Cafissimo TUTTOCAFFÈ HD8602 Bedienungsanleitung

INSTALLATION

Preparing for use

Remove the coffee machine from the packaging and put it in a
suitable place.

Preparing the machine for use

1- Remove the water tank from its base.
2- Remove the lid from the water tank.
Rinse the water tank and fill it with
fresh drinking water up to the MAX
level as indicated on the water tank.
3- Place the lid back on the water tank.
4- Place the water tank on its base.
Hot water or any other liquid may damage the tank
and/or the machine. Do not operate the machine
without water. Make sure that there is enough water in the
tank.
5- Insert the plug into a wall socket with suitable power voltage.
6-
panel.
7-
has yet been pumped into the system. Follow the instructions
described in the next paragraph.
Using the machine for the first time or after a
period of inactivity
At first start-up or in case you have not
used the machine for more than 2 weeks,
follow steps described below.
1- Rinse the tank and fill it with fresh
drinking water.
2- Ensure the lever is closed and place a
cup underneath the coffee dispensing
spout as shown in the picture.
Job:
Objekt:
Version: --
Seite:
3- Press the Caffè crema button
the capsule.
4- When the cup is full, press the Caffè crema button
the brewing process, then empty the cup.
Brewing will stop once the preset volume has been
reached.
5- Repeat steps 2 to 4 until all the water in the tank has been
dispensed.
6- When all the water has been dispensed, the service indicator
filling. Refill the tank and repeat steps 2 to 5.
7- Refill the water tank; the machine is now ready to brew coffee.

Automatic switch-off

The machine automatically switches off after 9 minutes of inactivity.
To reactivate the machine, simply press the
The machine can be turned off manually by pressing the

Adjusting the dispensing height

The machine can be used with a range of cup sizes.
The drip tray may be positioned on two levels to obtain different
brewing positions.
Follow the instructions below to position the drip tray at the desired
level:
on the control
Fig.1
1- Detach the drip tray from the machine by lifting slightly
outwards and upwards (Fig.1).
2- Attach the drip tray by inserting the pins into the appropriate
height slots and pushing slightly inwards and downwards
(Fig.2).
The drip tray may also be removed to create the highest possible
brewing position (Fig.3). In this case the cup is placed directly on
the machine base.
4219 440 12181
qInlet
q25
without inserting
.
Fig.2
Datum: 14-06-24
Uhrzeit: 09:13:16
von: timea.trojko
to stop
.
Fig.3