Nice Neomat T Installation Seite 6

4.1) Programming the transmitters
Table "A1" Memorizing the first transmitter (in Mode I)
1. Connect the motor to the power supply, 2 long beeps will be heard immediately
Within 5 seconds press and hold button ■ of the transmitter to be memorized
2.
(for approx. 3 seconds).
Release button ■ when you hear the first of the 3 beeps confirming memorization
3.
See table A2 for the memorization of additional transmitters
When one or more transmitters have already been memorized, others may be enabled as shown in table A2.
Table "A2" Memorizing additional transmitters (Mode I)
Press and hold down button ■ of the new transmitter (for approx. 5 seconds)
1.
until you hear a beep then release it
Press button ■ of a previously memorized transmitter slowly 3 times
2.
Press button ■ on the new transmitter again. Release button ■ when you hear the
3.
first of 3 beeps, signalling that memorization has been carried out
Note: If the memory is full (14 transmitters), 6 beeps will indicate that the transmitter cannot be memorized.
4.2) Programming of positions "0" and "1"
A remote control memorised in Mode I must be used to program the positions. The manoeuvres will remain hold-to-run until positions "0"
and "1" have been memorised in the control unit. To begin with, the direction of the motor is not defined but after point 1 in table A3 has
been completed the direction of the motor is automatically assigned to the remote control buttons.
Follow the procedure in table A3 to program the "0" and "1" positions:
Table "A3" Programming of positions "0" and "1"
Press and hold buttons ▲ or ▼ of a memorised remote control until the awning is fully
1.
closed and the motor automatically stops.
Press and hold button ▼ that lowers the awning
2.
Release button ▼ when the awning is in the desired position ("1").
3.
If necessary use the ▼ and ▲ buttons to adjust the position.
Press and hold button ■ of the transmitter until you hear a beep
4.
(after about 5 seconds) then release it
Release and press again button 5 for another 5 seconds until ■ rapid beeps are heard
5.
Press button ▼ until 3 beeps are heard and a short up and down movement occurs
6.
indicating that the position has been memorised
4.3) Optional programming
Optional programming is only possible after positions "0" and "1" have been programmed.
4.3.1) Memorisation of the intermediate position "I"
When an intermediate position "I" is memorised the awning can be manoeuvred into the "I" position by pressing the ▲ and ▼ buttons of the
transmitter together.
Follow the procedure shown in table A4 to memorise the intermediate position:
Table "A4" Programming of the intermediate position "I"
Using buttons ▲ ■ ▼ of a remote control, move the awning into the "I" position to
1.
be memorised
Press and hold down button ■ until you hear a beep (after about 5 seconds)
2.
Release and press again button ■ for another 5 seconds until 4 rapid beeps are heard
3.
Press buttons ▼ and ▲ together until 3 beeps are heard, indicating that the position
4.
has been memorised
6
Example
3s
Example
New 5s
Old X3
New
Example
5s
5s
Example
5s
5s