Set The Inverted Configuration; Enable The Illuminator Kit - Axis Q8685-LE Installationsanleitung

Set the inverted configuration

Note
This task only applies when using the inverted configuration.
Important
These instructions apply only to device firmware earlier than v8.40.
1. Go to the product's web page.
2. Go to Settings > System Options > Maintenance and click Default.
3. Wait for the camera to reset.
4. Go to the product's web page.
5. Go to Setup > PTZ > Advanced > Device > Extended Driver Specific Settings for
Video Source 1.
6. Go to Camera housing configuration and select Inverted.
7. Click Save.
Important
These instructions apply only to device firmware v8.40 or later.
1. Go to the product's web page.
2. Go to Settings > System > Maintenance and click Default.
3. Wait for the camera to reset.
4. Go to the product's web page.
5. Go to Settings > System > Plain Config > PTZ.
6. Go to Camera housing configuration and select Inverted.
7. Click Save.

Enable the illuminator kit

Important
These instructions apply only to device firmware earlier than v8.40.
1. Go to the product's web page.
2. Go to Setup > PTZ > Advanced > Device > Extended Driver Specific Settings for
Video Source 1.
3. For Illuminator > IL1 type:
— Select IR if you connected an infrared illuminator
— Select White for a white light illuminator
4. Repeat the above step for lluminator > IL2 type.
Important
These instructions apply only to device firmware v8.40 or later.
AXIS Q8685-LE PTZ Network Camera
43
EN