Maintenance; Disposal; Spare Parts - Honeywell TS131 Einbauanleitung

9. Maintenance

We recommend a planned maintenance contract with
an installation company
9.1. Inspection and Maintenance
• According to the requirements of DIN EN 12828, the
system operator is obliged to have the thermal
discharge safety valve checked by a professional at
least once a year to ensure its functioning capacity.
• To be carried out by an installation company
1. Check whether water is escaping from the housing
• if water is escaping, the seals (piston guide complete)
must be replaced or if necessary the unit must be
replaced
2. Operate the check valve and first check if water is running
off, then close the valve again
• if no water is escaping or the valve does not close, the
unit may have to be replaced
9.2. Cleaning
• To be carried out by an installation company
• To be carried out by the operator
Do not use any cleaning agents containing solvents or
alcohol to clean the plastic parts!
Detergents must not be allowed to enter the environ-
ment or the sewerage system!
MU1H-1543GE23 R0913
GB

10. Disposal

• Brass housing, bonnet and immersion pocket
• Copper temperature sensor
• Copper capillary tube
• Brass valve piston
• Hot-water-resistant elastomer seals
Observe the local requirements regarding correct
waste recycling/disposal!

11. Spare parts

TS131K-3/4S Piston guide, complete, for TS131
Only suitable for batches 1141 and up (2011,
calendar week 41 and later)
TS131TWG-3/4 Thermal expansion element for TS131
Opening temperature: 95° Type A = capillary
with protection sleeve, 1300 mm
Type B = capillary with protection sheath
4000 mm
Type ZAx = opening temperature according
to type (x = 50°C or 100°C ), capillary with
protection sheath, 1300mm
TS131IP-3/4 Immersion sleeve for TS131
5 Honeywell GmbH