Hensel EXPERT PRO 250 Bedienungsanleitung Seite 38

Manual EXPERT / INTEGRA PRO Compact
Default
factory setting:
Channel 1
36
The channel can be selected by pressing the Flash Control
Switch 13 once. By turning the knob channels from 1 to 4 can
be selected as shown on the LED display 14. After 3 seconds
delay the channel is set and the display changes to the flash
power setting.
Start-up and channel selection - Transmitter -
The Radio Transmitter has no built-in main switch for
switching the unit ON. The transmitter is to be connected to
the camera either by attaching it to the Hot Shoe of the
camera or by connecting the camera to the synchronization
socket 24 using the provided synchronization cable. If the
transmitter is connected to the Hot Shoe the unit must be
carefully tightened using the locking screw 25. Using the DIP
switch 6 at the bottom side of the unit the working channel can
be set. Combining both setting positions for the DIP switches
four different options are available. The same channel must be
set at the corresponding receiver. For channel setting, please
refer to the figure on page 1 of this manual.
Flash triggering
With correctly installed receiver and transmitter and proper
channel selection flashes can be released by pressing the
TEST button 23 or by releasing the camera shutter.
Additional features for PLUS versions:
Flash power adjustment and changing modeling light options
The buttons 21a and 21b allow further options for HENSEL
flash units with a built-in receiver. A single click on the
respective button reduces and increases the flash power by
1/10 f-stop. Pressing button 21a for longer than 3 seconds the
modeling light switches from FULL to OFF and PROP,
respectively.
The Receiver is equipped with an interface socket 30 for
HENSEL power packs.
Maintenance
The HENSEL Remote Control System RC/RF
maintenance-free. Because of the low energy consumption of
the transmitter a battery
assumed depending on the degree of utilization.
lifetime of 1 to 2 years can be
HENSEL Studiotechnik
is almost