Roth Basicline T Installationshandbuch Seite 90

Installation - Device Parameters
DX FUNCTION
D01 Heating
Control
D02 Room
Temperature
Offset
D03 Sensor probe or
Cylinder thermostat
connection
D04 Sensor probe
used as air sensor
or floor sensor
D05 Cooling Control
D06 Actuator type
D07 Valve protection
90
Installer Manual
SYSTEM SETTING
0 Pulse Width Modulation
1 On-Off 0.5 Deg C +/- 0.25 Deg C
2 On-Off 1.0 Deg C +/- 0.5 Deg C
-3.0 to 3.0 Temperature Offset from
Deg C Measured Temperature to
Compensate for any error
0 Sensor stat not Connected
1
0 D03 must be set to 1 then
external sensor be used as
Air sensor. There will be no
internal temp measurement
1 D03 must be set to 1 then
external sensor used for floor
protection. Internal temp is
1 On-Off 0.5 Deg C +/- 0.25 Deg C
2 On-Off 1.0 Deg C +/- 0.5 Deg C
0
1
0
1
DEFINITION
Sensor stat Connected
measured by stat
NO Normally Open
NC Normally Closed
Disable
Enable
DEFAULT
0
0 Deg C
0
0
2
1
1