Introduction; Configuration; General; Startup Wizard - SystemAir SAVE VTC 700 Bedienungsanleitung

GB
4

Introduction

The SAVE VTC 700 is a heat recovery ventilation unit with a built in counter flow plate heat exchanger. There are two
model options, right (R) and left (L) model (figure 1).
This manual describes basic information how to operate and perform maintenance on the unit and the system it is con-
nected to.
Table 1 Symbol description
Symbol
5

Configuration

5.1

General

SAVE VTC 700 has a modern touchscreen LCD control panel, simply known as HMI — Human Machine Interface. The
touchscreen display provides information about current state of the unit and allows you to control all system functions.
Settings are done by touching the icons or options. The touch screen is sensitive and it is not necessary to press too
hard.
5.2

Startup wizard

During the first power up of the unit, you will be asked to set:
• menu language
• time and date
• import configuration file (if the Internet Access Module (IAM) with configuration file is available)
• airflow control type (Manual/RPM) and airflow level values
• heater type (None/Electrical/Water/Change-over)
The Startup Wizard cannot be skipped.
5.3

Common symbols

The following selection symbols are common and are present in most menu pages:
Back button to return to a previous
menu, located at the upper left corner
Up arrow to increase a value
Down arrow to decrease a value
Some menus have more than one page. Touch page indicator in the top right corner to go to the next page. The first
number indicates current page number and the second number indicates a total number of pages available.
Many options show up in a form of the pop-up window. Select the option from the displayed list in the pop-up window
and press OK to confirm selection.
211468 | A004
Description
Supply air
A
B
Exhaust air
C
Outdoor air
D Extract air
B
A
C
D
Fig. 1 Right and Left models
On and Off slider to activate or
deactivate a function. White bubble —
function is inactive, green bubble —
function is active.
Button to cancel changes
CANCEL
Buttons to confirm changes
SET/OK
7
Introduction |
B
A C
D