Safety And Installation Instructions - Waeco MagicSpeed HUD Montage- Und Bedienungsanleitung

Safety and installation instructions

2 Safety and installation instructions
Please observe the prescribed safety instructions and stipulations from the
vehicle manufacturer and service workshops.
Caution!
WAECO International will not be held liable for claims for damage
resulting from the following:
– Installation errors
– Damage to the appliance resulting from mechanical influences and
excess voltage
– Alterations to the device made without the explicit permission of
WAECO International
– Usage for purposes other than those described in the instruction
manual
Warning!
To prevent short circuits, always disconnect the negative terminal of the
electrical system before working on it. If the vehicle has an additional
battery, its negative terminal should also be disconnected.
Warning!
Inadequate cable connections can cause short circuits, resulting in:
– Cable fires
– The airbag being triggered
– Damage to electronic control equipment
– Electrical malfunctions (indicators, brake light, horn, ignition, lights)
Please observe the following instructions:
When working on the following cables, only use the cable connectors supplied:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return line from the battery, earth).
Do not use terminal strips.
Screw the cable for connections to wire 31 (earth)
– Screw on the cable using a cable lug and serrated washer with one of the
vehicle's earth bolts
– Screw the cable to the bodywork using a cable lug and a self-tapping screw
Make sure there is a good earth connection.
18
MagicSpeed HUD