G&D DL-DVI-Vision-CAT Installation Und Bedienung Seite 74

Installation
Connecting audio and RS232 interfaces
USB 2.0 Trans.
Transmission
Micro In: If required, connect a microphone to this interface.
Speaker: Connect the speakers or another audio output device.
Connect the serial end device to this interface.
RS232:
Connecting further interfaces of ARU/ARU2 variants
USB 2.0 Trans.
Transmission
USB 2.0 Devices: Use the two interface on the back and the two interfaces on the front
to connect USB devices.
NOTE: The USB 2.0 Devices
data rates:
 ARU variants: full speed
ARU2 variants: high speed

USB 2.0 Trans. Plug a category 5e (or better) twisted pair cable, which is available as
accessory, into this interface of the
to the USB 2.0 Trans.
7 · G&D DL-DVI-Vision-CAT
Serial
USB 2.0 Devices
DVI-D DL Out Micro In Speaker
Serial
USB 2.0 Devices
DVI-D DL Out Micro In Speaker
interfaces of
ARU2
interface of the computer module.
Mouse
Generic
Keyb./Mouse Keyb. Red. Power
Mouse
Generic
Keyb./Mouse Keyb. Red. Power
ARU and ARU2 variants support different
variant. Connect the other end of the cable