Bodum 11001 Bistro Gebrauchsanweisung Seite 7

water after use.
WARNING: The thermal jug (8) is not suitable for washing in
the dishwasher. Do not immerse the thermal jug in water.
The thermal lid cap (10) can be removed trough pull from the
thermal lid (9) for ease of cleaning. Both the thermal lid and
lid cap are dishwasher safe.
Ensure that no ground coffee remains in the coffee filter (7).
POWER BUTTON
INDICATOR
LIGHT
MAINTENANCE De-Scaling The Automatic Pour Over Coffee Machine
AND CARE
To guarantee that the Automatic Pour Over Coffee Machine
works correctly, you have to ensure that the machine is kept
free of lime-scale. The optimum cycle is dependent on the
hardness of the water which is different from country to
country. We would advise de-scaling the machine after every
100 uses.
Important: If you do not de-scale the Automatic Pour Over
Coffee Machine then this can lead to damage!
If over scaling switches the appliance off automatically
the ON/OFF switch (15) will illuminate red. You then
must de-scale the Automatic Pour Over Coffee Machine
ON/OFF flashing green during brewing
process indicates normal operation /
status OK.
ON/OFF solid green after brewing
process is complete indicates normal
operation / s tatus OK.
ON/OFF flashing red during the brewing
process indicates the water tank is empty
and requires refilling.
ON/OFF solid red after brewing process
is complete indicates the product requires
a de-scale. Please refer to recommenda-
tions and instructions on page 13.
12
immediately because the machine will no longer operate.
Regular de-scaling can increase the service life of the prod-
uct and guarantees its faultless functionality. Furthermore,
regular de-scaling will result in less steam forming, faster
brewing times and energy savings.
Deposits should be removed with a commercially available
de-scaling solution for coffee machines or with a solution
of vinegar and water (20% vinegar and 80% water). When
using commercially available de-scaling solutions ensure
that these are suitable for use with heating elements made
of copper as well as silicone materials. (Carefully check the
specifications and dosage instructions of the manufacturer).
Fill the water tank (2) with descaling solution or a vinegar
and water solution (do not fill above the MAX line) and place
the pour over coffee shower (11), filter holder (6), coffee fil-
ter (7) (without ground coffee) and the thermal jug (8) with
the thermal lid (9/10) into their intended positions in the
appliance.
Then rinse the separate parts thoroughly with cold water and
rinse the appliance by running through with cold, clear water
at least twice. Prior to doing so ensure that all of the sepa-
rate parts have been correctly reassembled in the Automatic
Pour Over Coffee Machine.
Any other servicing should be performed by an authorized
service facility.
CLEANING THE
The pour over coffee shower (11) can be cleaned and
COFFEE SHOWER
de-scaled separately. In order to do so remove the housing
lid (5) from the body (1) of the Automatic Pour Over Coffee
Machine. Then carefully lift the pour over coffee shower
(11) vertically, up and out of the Automatic Pour Over
Coffee Machine. Now remove the large stopper (12) and
small stopper (13) by pulling these slowly out of the coffee
shower. Clean all parts thoroughly with descaling solution.
Subsequently rinse all parts thoroughly with clear water
before putting the coffee shower carefully back together.
Ensure that the large stopper and small stopper are correctly
seated and firmly in place. Now place the coffee shower
back in the Automatic Pour Over Coffee Machine and care-
fully replace the housing lid.
13
EN